2nd Generation S-series (1995-2005) Tech. However I noticed from the wiring harness going into my fuel pump is spliced and goes to two different things. Well, you are at the perfect place to find the answer to such a question. Considering that fuel requirements at idle are significantly less than at wide open throttle, a. It would have come with your fuel pump. Coat the bare metal with silicone grease. Don't want to drive it til I know what the problem is and it is fixed. I tried to find the ground wire for the fuel pump but didn't find it. Kind of a poor setup for this I think, but anyway: # 24. First I check Check Replaced fuse and it still wont start. The only practical way to access it is to remove the dash pad and go in through the top. 1994 CHEVROLET 1500. Solder the connection.
- Fuel pump ground wire location 2007 dodge charger 3 5
- Fuel pump ground wire location on 1994 dodge ram 2500
- Wiring a fuel pump
- S10 fuel pump ground wire location
Fuel Pump Ground Wire Location 2007 Dodge Charger 3 5
You will be able to get around this by properly sheathing the fuel pump wires. It is located at the left front of the engine. I am in process of doing this now.
Fuel Pump Ground Wire Location On 1994 Dodge Ram 2500
Get a pic and head to your local carquest. It's not the cluster, pump or pump harness so I'm now searching for a loose or pulled ground wire. 06-20-2018 05:45 AM. Not sure I can add any more here - can you get the pump to turn on with 12v directly at the pump connector?
Wiring A Fuel Pump
Come join the discussion about performance, builds, engine swaps, turbos, modifications, classifieds, troubleshooting, maintenance, and more! I don't think my car has it, as I didn't find any misc. 04-02-2016 07:47 AM. Last edited by nycgps; 03-05-2014 at 05:51 AM. If it lights for a couple of seconds, then it's getting the signal from the ecm. That wire is going to terminal 30 on the fuel relay. The car is running on sds so no factory harness. Note the wiring harness wires (including ground) and bonding wire run down along the
fuel pump together. You should find something that is causing your problem. Do you know a network tech? With the test light probe on that grn/wht pin, turn the key on. I have replaced the the other fuses test for 12v but the fp fuse. That would be to the green/white wire, can't remember what pin it is, but there's only one grn/wht.
S10 Fuel Pump Ground Wire Location
Also, when I was out trying to start my car, I wasnt hearing the relay click at all? Look at the voltage of your fuel pump. Check your two oil pressure senders. That ground has to end somewhere, thats what I'm trying to figure out. When touching the ground on the pump and one of the black wires... Thread.
Bed is coming off for paint, new tail lights, and I will rewire for trailer brakes/lights and peekaboo back up lights. Join Date: Jun 2000. Cut the pink wire, leaving a short length of wire going to the plug, so that you can repair the cut should you ever want to return the car to stock. Bring it to the back of the jeep plug it in and it still doesn't try to prime. Should You Get Your Fuel Pump Direct Wired By a Professional? Fuel pumps aren't really designed for direct wiring. In order to login you must be registered. If you are worried about sparks, you could remove the pump from the tank and work on it well away from the tank. As counter intuitive as it may seem, sometimes upgrading a fuel pump without upgrading the wiring can actually decrease fuel flow.